User Manual
Table Of Contents
- Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Quickstart Guide
- 2.1 Connect Your Console to the Sound Card or External I/O
- 2.2 Create a New Session and Set the Preferences
- 2.3 Add Empty Racks
- 2.4 Add Plug-ins for Sound Processing
- 2.5 Snapshots
- 2.6 Create Processing Groups
- 2.7 Saving in MultiRack
- 2.8 Recall Safe Mode
- 2.9 Overview Window: Viewing the Status of All of Your Racks
- 2.10 Controlling MultiRack with MIDI
- 2.11 Show Mode
- 2.12 Shortcuts That Are Always Available
- 2.13 Automatic Recovery
- Chapter 3 - MultiRack Windows and Controls Explained
- Chapter 4 - MultiRack Menus
45
• Set MIDI Control Change messages for snapshots recall determines which control
messages — sent on the above-set MIDI channel — will be used to initiate/recall
Snapshots #129-1000. For example, if you select Control Change message #7 to recall
Snapshots 129-256, then sending CC#7 with value 0 will recall Snapshot #129. Value 2
will recall Snapshot #130, and so forth.
• Set MIDI Pickup Mode determines how MultiRack will respond to parameter changes.
When None is selected, all user changes are directly reflected in the interface.
Takeover move means that existing parameter values will not change until you have
“swept” over it in either direction.
• MIDI/Keyboard Setup File allows you to browse to the control file created in the
Remote Controller Editor. Choose the file that contains the MIDI mapping for your
hardware setup.
You can open the Remote Controller Editor from this page. If you opened the editor from
the Control Setup Tab and MultiRack is still open, settings will automatically update as the
file is modified.