User Manual
Table Of Contents
- Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Quickstart Guide
- 2.1 Connect Your Console to the Sound Card or External I/O
- 2.2 Create a New Session and Set the Preferences
- 2.3 Add Empty Racks
- 2.4 Add Plug-ins for Sound Processing
- 2.5 Snapshots
- 2.6 Create Processing Groups
- 2.7 Saving in MultiRack
- 2.8 Recall Safe Mode
- 2.9 Overview Window: Viewing the Status of All of Your Racks
- 2.10 Controlling MultiRack with MIDI
- 2.11 Show Mode
- 2.12 Shortcuts That Are Always Available
- 2.13 Automatic Recovery
- Chapter 3 - MultiRack Windows and Controls Explained
- Chapter 4 - MultiRack Menus
None
A group is created, but there is no latency alignment.
Auto
The group is delayed to match the latency of the Rack in the group
with the greatest total latency.
Manual
Manually delay the group by a specific value by entering it in the
Latency field. The value is displayed in samples, milliseconds,
meters or feet, depending on your choice in the pull-down window.
The minimal value allowed for this setting matches the latency of the
Rack in the group with the greatest total latency.
Groups are color-coded to make for easier identification. Color selection is based on
placement in the list, and is not user-definable. At the bottom of the Group Properties page
is the Align All section.
Here you can align all of the groups of Racks in order to create a unified timing for all
channels. The Auto setting will offset all of the groups to match the timing of the group with
the greatest latency, while Manual will delay all groups by a specific value.
Below the Align All section is the “Speed of Sound” setting. This parameter control,
expressed in meters per second, allows you to calibrate MultiRack’s latency controls to
match measured speed of sound. The speed of sound at sea level, at a temperature of 20
degrees Celsius and dry air, is 343 meters per second.
38