User Manual
Table Of Contents
- Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Quickstart Guide
- 2.1 Connect Your Console to the Sound Card or External I/O
- 2.2 Create a New Session and Set the Preferences
- 2.3 Add Empty Racks
- 2.4 Add Plug-ins for Sound Processing
- 2.5 Snapshots
- 2.6 Create Processing Groups
- 2.7 Saving in MultiRack
- 2.8 Recall Safe Mode
- 2.9 Overview Window: Viewing the Status of All of Your Racks
- 2.10 Controlling MultiRack with MIDI
- 2.11 Show Mode
- 2.12 Shortcuts That Are Always Available
- 2.13 Automatic Recovery
- Chapter 3 - MultiRack Windows and Controls Explained
- Chapter 4 - MultiRack Menus
31
Active(On)
Turns Rack on/off, disabling and removing it from the
CPU. This is useful for greater CPU efficiency when a
Rack is not needed.
Bypass
Disables the Rack’s plug-in processing and passes
signal from Rack input to Rack output.
Mute
Mutes entire Rack but doesn’t remove plug-ins from
CPU.
Cut Rack(s)
Cuts the Rack and its contents and places them in the
computer’s clipboard.
Copy Rack(s)
Copies the Rack and its contents into the computer’s
clipboard.
Paste Rack(s)
Pastes the Rack, including its content and state.
Duplicate Rack(s)
Creates a copy of the Rack, including its content and
state.
Delete Rack(s)
Deletes the Rack. Racks below this Rack will move
upward.
Global Paste Rack
Copies the Rack’s parameters from the
recalled
Snapshot and pastes them into the
selected Snapshots
when “Global Paste” is selected in the Snapshot Pane.
For example, if your singer has a cold and you need to
EQ the vocals differently, Global Paste allows you to
change specific settings, then embed these parameter
changes into all of the Snapshots you’ve made, rather
than having to adjust each Snapshot separately. The
Global Paste function is discussed in detail in the
“Snapshots” section of this manual.