User Manual
Table Of Contents
- Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Quickstart Guide
- 2.1 Connect Your Console to the Sound Card or External I/O
- 2.2 Create a New Session and Set the Preferences
- 2.3 Add Empty Racks
- 2.4 Add Plug-ins for Sound Processing
- 2.5 Snapshots
- 2.6 Create Processing Groups
- 2.7 Saving in MultiRack
- 2.8 Recall Safe Mode
- 2.9 Overview Window: Viewing the Status of All of Your Racks
- 2.10 Controlling MultiRack with MIDI
- 2.11 Show Mode
- 2.12 Shortcuts That Are Always Available
- 2.13 Automatic Recovery
- Chapter 3 - MultiRack Windows and Controls Explained
- Chapter 4 - MultiRack Menus
14
2.7 Saving in MultiRack
MultiRack offers four different levels of “Save,” enabling you to quickly and confidently store
and recall needed Session information. From most specific to most general, here are your
options for saving information:
• Per Plug-in: Each plug-in has its own WaveSystem Toolbar, so you can load and save
your favorite plug-in settings without affecting the rest of the processing environment.
Say you have a C4 preset that you’d like to use for the bass. Simply load the preset
from the C4’s WaveSystem Toolbar’s Load menu.
• Per Rack: There’s a WaveSystem Toolbar at the top of each Rack, so you can load and
save settings for an entire Rack, independent of the Snapshots.
• Snapshots are used to store your plug-in and Rack settings.
• Sessions hold the settings for every plug-in, Rack and Snapshot, and contain the
information about the architecture and signal flow for the entire setup.
2.8 Recall Safe Mode
There are times when you don’t want certain Racks or specific plug-ins to be affected by
Snapshot changes. The Recall Safe Mode allows you to select the Racks and/or plug-ins
that won’t be affected as you change Snapshots that would normally affect them. The
recall-safe option applies within the Session (not a specific Snapshot).
To set a Rack or plug-in to Recall Safe:
• Select Recall Safe in the Snapshots menu, or type Ctrl/Cmd+Shift+R.
• Racks: Select a Rack or multi-select several Racks, then right click in any empty area of
the Rack. Select Recall Safe from the pull-down menu. A Rack’s blue input/output rails
indicate that it is in Recall Safe.
• Plug-ins: Select the plug-in or plug-ins you want to set to Recall Safe. Right click on any
of the selected plug-ins and choose Recall Safe from the pull-down menu. Recall Safe
plug-ins glow blue.
• To remove a Rack or plug-in from Recall Safe mode, de-select Recall Safe from the
right click menu in Recall Safe mode.
• Plug-ins or Racks that are set to Recall Safe can be edited. However, their Recall Safe
status can be viewed only while in Recall Safe mode.
• Selecting Recall Safe in the Snapshots menu does not activate or de-activate Recall
Safe. Rather, it only allows you to see plug-ins and Racks and set them to Recall Safe.