Specifications

55
AT83SND2CMP3
7524D–MP3–07/07
Table 51. R3 Response Format (OCR Register)
Table 52. R4 Response Format (Fast I/O)
Table 53. R5 Response Format
Data Packet Format There are 2 types of data packets: stream and block. As shown in Figure 44, stream
data packets have an indeterminate length while block packets have a fixed length
depending on the block length. Each data packet is preceded by a Start bit: a low level
on MCMD line and succeeded by an End bit: a high level on MCMD line. Due to the fact
that there is no predefined end in stream packets, CRC protection is not included in this
case. The CRC protection algorithm for block data is a 16-bit CCITT polynomial.
Figure 44. Data Token Format
Clock Control The MMC bus clock signal can be used by the host to turn the cards into energy saving
mode or to control the data flow (to avoid under-run or over-run conditions) on the bus.
The host is allowed to lower the clock frequency or shut it down.
There are a few restrictions the host must follow:
• The bus frequency can be changed at any time (under the restrictions of maximum
data transfer frequency, defined by the cards, and the identification frequency
defined by the specification document).
• It is an obvious requirement that the clock must be running for the card to output
data or response tokens. After the last MultiMedia Card bus transaction, the host is
Bit Position 47 46 [45:40] [39:8] [7:1] 0
Width (bits) 1 1 6 32 7 1
Value ‘0’ ‘0’ ‘111111’ - ‘1111111’ ‘1’
Description
Start bit
Transmission
bit
Reserved
OCR
register
Reserved End bit
Bit Position 47 46 [45:40] [39:8] [7:1] 0
Width (bits) 1 1 6 32 7 1
Value ‘0’ ‘0’ ‘100111’ - - ‘1’
Description
Start bit
Transmission
bit
Command
Index
Argument CRC7 End bit
Bit Position 47 46 [45:40] [39:8] [7:1] 0
Width (bits) 1 1 6 32 7 1
Value ‘0’ ‘0’ ‘101000’ - - ‘1’
Description
Start bit
Transmission
bit
Command
Index
Argument CRC7 End bit
0 Content 1
Sequential Data
CRCBlock Data 0 Content 1
Block Length