User`s guide

Interpreting Screen Displays
MS-4900, Rev. A 4–11
SNMP Trap IP
Address
This is the address of the computer running the SNMP manager software and to
which the IDR V1000 can report its status events (such as acquiring or losing carrier
lock). Assuming both the SNMP server and the IDR V1000 are connected to the
Internet, you can poll the receiver status from anywhere in the Internet.
NOTE: This address must be set to either the SNMP manager address (to report
status), or all zeroes (to not report status).
Host IP Address
The host IP address is that of the end user PC receiving the IDR V1000 output data.
This establishes a point-to-point connections between the IDR V1000 and the
individual PC. A valid address is required in this screen if the IDR V1000 must
initiate the connection to the PC using either a TCP/IP socket connection or a Unicast
socket connection based on UDP packets.
Specify Setup:
IP Addresses
Through the Specify Setup: IP Addresses screens, you can change IP-related
addresses locally. Be sure to notify the network operator anytime such changes have
been made.
Changing an
Address
To change an address, you must step through all 12 character (all four fields) of the
address.
• Use the < and > buttons to increase or decrease a number.
• Press SELECT to confirm the number.
• Press CANCEL to return to the previous number without updating the current
number.
If you press SELECT through each of the fields of the IP address, the address is
confirmed and saved to memory. If you exit the screen by pressing CANCEL, no
changes are saved, and the receiver continues to use the previously loaded address.