User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer˚III OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A – Guide to Desense
- Appendix B - Numeric Conversion Chart
- Appendix C – Boomer-III Specifications
- Appendix I - Glossary
Wavenet Software Development Tools__________________________ Boomer-III User Manual & Integrator’s Guide
Copyright Wavenet Technology © October 2003 60 BM310012WT05
Wavenet Commander
The radio service utility software “Wavenet Commander” enables a
user to exercise and configure Wavenet Modems. This software runs
under Windows 95, 98, NT, or 2000.
Wavenet Commander interfaces with the Boomer-III OEM Modem via
a PC’s communications port and the Test Jig’s PC port using an
RS-232 cable.
Wavenet Commander is issued as an install shield and will create the
following files in the user designated installation directory:
WC_End_User.wcu The executable file
user_defined.def Definition file for User Scripts
masc_generic.def Default MASC Commands.
A typical screen shot from Wavenet Commander is shown below.