User Guide
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Mounting the Boomer II OEM Modem to Your Device
- Connecting the Data Interface Port
- Selecting & Positioning the Antenna
- Supplying Power
- Using the Modem Test Jig
- Software Development Tools
- Integration Testing
- Appendix A - NCL Interface
- Appendix B – SDK NCL-API and Port Server
- Multisession API
- Application Interface
- _
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- _
- A
- Appendix C – SDK Sample programs
- Appendix D - Application Development
- Appendix E - Message Routing and Migration
- Appendix F – Guide to Desense
- Appendix G - Numeric Conversion Chart
- Appendix H - Specifications
- Appendix I - Glossary
Wavenet Software Development Tools___________________________ Boomer II User Manual & Integrator’s Guide
Copyright Wavenet Technology © October 2003 64 BM210012WT35
Wavenet Commander
The radio service utility software “Wavenet Commander” enables a
user to exercise and configure Wavenet Modems. This software runs
under Windows 95, 98, NT, or 2000.
Wavenet Commander interfaces with the Boomer II OEM Modem via
a PC’s communications port and the Test Jig’s PC port using an
RS-232 cable.
Wavenet Commander is issued as an install shield and will create the
following files in the user designated installation directory:
WC_End_User.wcu The executable file
user_defined.def Definition file for User Scripts
ncl_generic.def Default NCL Commands.
Refer to Appendix A - NCL Interface for the NCL command list.
A typical screen shot from Wavenet Commander is shown below.