User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Boomer II User Manual & Integrator’s Guide _________________________________________________Installation
BM210012WT27 49 Wavenet Technology
Power-Up Timing Diagram
Note: HCRESET, CTS, DSR, DCD, the LEDs and the internal modem reset are all
active low signals.
Power Up Diagram Callouts
1 Power is supplied to the modem
2 The HOSTPWR_ON signal is asserted to turn on the modem.
3 The HCRESET signal is de-asserted.
4 The internal modem reset is released to allow the modem boot up
sequence.
5 The modem exits the boot load state, is operational and is ready to
communicate with the DTE.
Modem Internal Power
Modem Internal Reset
CTS
DSR
DCD
LED’s
~ 300 ms
Initialisation
4
5
Boot Stage
Modem is now
software controlled
Modem is now
O
p
erational
Network Connect
IN RANGE
Optional Delay
1
HOST 3.8V
HOSTPWR_ON
2
HCRESET (Optional)
140 ~ 280 ms
Reset Delay
3
Optional
Delay