User's Manual
Table Of Contents
- Introduction
- The Integrator’s Task
- Installing the Modem
- Using the Modem Test Jig
- Testing
- Desense
- Application Development
- Message Routing and Migration
- Appendix A - NCL Interface
- Appendix B - Software Development Kit
- SDK Contents
- System Requirements
- SDK Software Architecture
- NCL Application Programmer’s Interface
- Implementation
- Logical Architecture
- Application Interface
- Opening a Session
- Close Session
- Send Data to a Radio Host
- Receive Data From RPM
- Get RPM Status Information
- Set Configuration ITEMS Within the RPM
- Reset RPM
- Register Event Callback Function
- Enable / Disable Events
- Get Error Description
- Register Wakeup Application
- Deregister Wakeup Application
- Switch RPM On/Off
- Send Generic NCL Command To RPM
- Get Software Version
- SCR Application Programmer’s Interface
- A
- Appendix C – Sample programs
- Appendix D - Wavenet Application Loader
- Appendix E - Numeric Conversion Chart
- Appendix F - Specifications
- Appendix H - Glossary
Installation_________________________________________________ Boomer II User Manual & Integrator’s Guide
Wavenet Technology 38 BM210012WT27
Status Input/Output Interface Definitions
J1
Pin #
Signal Description Signal Active State
16 SS0 Status Signal 0 Input/ Output User configurable (future option)
17 SS1 Status Signal 1 Input/ Output User configurable (future option)
18 SS2 Status Signal 2 Input/ Output User configurable (future option)
19 SS3 Status Signal 3 Input/ Output User configurable (future option)
LED Indicators
The modem provides three on-board indicators (LEDs), for diagnostic
monitoring purposes as well as three modem controllable LED outputs
through the Data Interface Connector.
On-Board LED Indicators
The on-board LEDs are visible through a small window in the case of
the modem and are defined as below.
On-Board LED Indicator Definitions
Operating Mode
LED Indicator Colour
Off On Flashing
P
OWER
Green Power off
Power normal and
locked on channel
Power normal and
scanning channels
T
RANSMIT
D
ATA
Red No activity N/a Data Transmitted
R
ECEIVE
D
ATA
Green No activity N/a Data Received
Note: The LEDs may be disabled to minimise power consumption.
Refer to Appendix A – Wavenet Specific NCL Extensions. All LEDs will
flash on start-up and the Receive and Transmit LEDs will flash on
power down regardless of the state of the LED disable control.
Position of On-Board LED Indicators
Power
Receive
Transmit