User Manual

Boomer II User Manual & Integrator’s Guide
________________________________
________________
Introduction
BM210012WT09 7 Wavenet Technology
Introduction
The Boomer II OEM Modem is a radio packet modem, intended for
use on the Motorola DataTAC 4000 SFR and DataTAC 5000 MFR
data communication networks.
It is primarily designed to be integrated into customer equipment as an
OEM modem. There are two versions available, an 800MHz version (A
band) and a 900MHz version (B band).
The modem interfaces to the equipment’s controller by using the data
interface port. The protocol supported over this link is Native Control
Language (NCL).
Although the modem has embedded software, it has no built in
application software. All application software must be separately
installed and run from the device to which the modem is connected.
A Software Development Kit (SDK) is available and described later in
this manual to assist this process.
A picture of the Boomer II OEM Modem is shown below.
This manual contains the following sections:
Section 1: General product information.
Section 2: Installation Guide.
Section 3: Test Jig and Boomer II Evaluation Guide.
Section 4: Software Development Kit Guide for the modem interface
(NCL) and the network host interface (SCR).
Section 5: Client Application Guide.
Section 6: Message Routing Guide.
LED
Window
Data Interface Port
RF Connector