User Manual

Boomer II User Manual & Integrator’s Guide
________________________________
___________________
Test Jig
BM210012WT09 29 Wavenet Technology
Use the following procedure to remove the cable from the FPC
connector.
a. Lift up the lock lever of the FPC connector by flipping it
up with the nail of your thumb or index finger.
b. Remove the cable after the lock is released.
2. Install an antenna to the modem. Use either the on-board SMA
connection and an adapter cable between the modem MMCX
connector and the test jig, or directly to the modem itself.
3. Connect the PC to the DB9 connector marked “PC” using a
standard serial cable.
4. Switch the power supply on.
5. Select the DIP switch labelled H-P-ON to the ON position.
The Power LED on the modem should illuminate.
You are now ready to communicate with the modem using the
PC as a host.
The modem should be able to talk to the PC by using Wavenet
RSUSER software, or other NCL protocol software.
Lock Lever