User Manual

Boomer II User Manual & Integrator’s Guide
________________________________
___________________
Test Jig
BM210012WT09 23 Wavenet Technology
Test Jig
The Boomer II Test Jig provides RS-232 serial interface ports between
a PC and the modem. It is designed to enable you to quickly interface
the Boomer II to a standard PC (through a COM port) or a terminal
device with an RS-232 serial port.
The test jig acts as a temporary host for the modem and provides access
points to the radio’s communication port, allowing you to monitor
activity with a logic probe, multimeter or oscilloscope.
Features
q All Input/Output Lines configurable by jumpers and/or
accessible through parallel FPC connector.
q On-board dual RS232 Serial Communication interface ports
with DB9 connectors
q Through the SPY MODEM connector, you can monitor the data
transmitted from the modem (RX, DSR, and CTS).
q Through the PORT 2/SPY PC connector, you can monitor the
data transmitted from the PC (TX, RTS and DTR), or talk to the
second serial port of the modem. You can make this choice by
putting all five jumper links on the right or left side of the RDW
header connector near the port.
q Switches and LED indicators on SS0 - SS3 modem I/O lines.
q On-board voltage regulator for Boomer II OEM supply rail.
q On-board LEDs for three external signals:
Low battery
Message waiting
In range
q On-board antenna matching network allowing conversion from
MMCX to SMA connectors.