User Manual

Boomer II User Manual & Integrator’s Guide
________________________________
___
Appendix A - NCL Interface
BM210012WT09 121 Wavenet Technology
q Generic set RPM Configuration command
(WN_SET_PARAM):
This command allows the DTE to set the configuration settings of
certain aspects of the modem.
FORMAT:
WN_SET_PARAM Command Syntax (NCL string “ZF^…”):
WN_SET_PARAM Response Syntax:
q OPERAND DESCRIPTIONS AND RESPONSES:
The various Vendor Parameter settings that can be made are described
as follows. Please note that all multiple byte fields are stored MSB
first. Numbers prefixed with “0x” are expressed as hexadecimal.
“Byte” (optionally followed by a sequence number) is used to indicate
a single byte.
Parameter Number A 16-bit field, which is unique to each
parameter, used to differentiate them.
Parameter Length A 16 bit field, which indicates the length
of the following parameter, in bytes.
Parameter Contents The actual bytes set for the parameter.
The format is parameter specific.
The Parameter Name is a label used to refer to particular parameters,
and is used as a definition for the parameter number.
WN_SET_PARAM : Set Modem Configuration (NCL string
“ZF^[2 byte parameter number][2 Byte
parameter length][parameter block..]”).
RESP Length SDU Tag VENDOR
SUCCESS
VEND_WAVENET
CMND Length SDU Tag
VENDOR
‘Z’
‘F’ ‘^’
WN_SET_PARAM
VEND_WAVENET
Parameter number Parameter length
Parameter
contents …