User Manual

ManualsBrandsWavenet Technology ManualsElectronicsWireless OEM Modem Module

111

112

113

114

115

116

117

118

119

120

Boomer II User Manual & Integrator’s Guide

________________________________

___

Appendix A - NCL Interface

BM210012WT09 111 Wavenet Technology

Commands Value Parameters Value Sub-values and Descriptions

R_SYSID ASCII C Vendor-specific: Get system ID of current RF system.

R_SW_VERSION ASCII D Get software version number.

R_RPM_ID ASCII E Get RPM address.

R_RF_BLOCK_SHORT ASCII E Vendor-specific: Get short form of RF status block.

ASCII F Reserved.

R_MAX_DATA_SIZE ASCII G Get SDU data limit.

R_RPM_GID ASCII H Get RPM group IDs.

R_WAN_TYPE ASCII I Get WAN Type Code.

R_RF_VERSION ASCII J Get RF protocol version number.

R_VENDOR_ID ASCII K Get vendor information: VEND_MOTOROLA Vendor is Motorola

ASCII 0

ASCII

L..Z

Reserved.

R_RCV_MODE ASCII a Get mode of notification to the DTE for received SDUs.

R_RX_STATUS ASCII b Get receiver enable status.

R_TX_STATUS ASCII c Get transmitter enable status.

R_ANTENNA ASCII d Get antenna selection status.

R_RADIO_IN_RANGE ASCII e Get radio in range status.

R_OB_MSG_COUNT ASCII f Count of outbound messages queued.

R_IB_MSG_COUNT ASCII g Count of inbound messages queued.

R_FLOW_CONTROL ASCII h Get flow control status.

R_EVENT_STATES ASCII i Get current event reporting enable/disable state.

R_RADIO_CHANNEL ASCII j Get current radio channel.

R_CHAN_BLOCK ASCII k Get RPM RF channel status block.

R_RF_STATISTICS ASCII l Get RPM RF statistics block.

R_BAT_LEVEL ASCII m Get battery status.

ASCII n..x Reserved.

R_DCHAN_TABLE ASCII y Read dynamic channel table.

R_CHAN_TABLE ASCII z Read static channel table.

SET_CNF ASCII 5 Set modem configuration.

S_RCV_MODE ASCII A Select the confirmed/unconfirmed Receive Data mode.

S_INACTIVITY_

TIMEOUT

ASCII A Vendor-specific: Set read time for outbound packet.

S_TX_CONTROL ASCII B Enable/disable the transmitter.

S_RX_CONTROL ASCII C Enable/disable the radio.

S_FLOW_CONTROL ASCII D Select the flow control method:

FLOW_NONE No flow control. ASCII 0

FLOW_XONXOFF XON/XOFF ASCII 1

FLOW_RTSCTS RTS/CTS ASCII 2

S_RADIO_CHANNEL ASCII E Select the radio channel.