User's Manual

- 16 -
3.3.3 AT+R103
Function RF link rate
Example TX AT+R103=<RF Baud Rate>[Enter]
Example RX OK[Enter]
Parameter <RF Baud Rate> 0 : 100kbps (Default)
1 : 250kbps
Remark
Table 13. AT+R103 description
3.3.4 AT+R120
Function RF paring module setting
Example TX AT+R120=<Mac Address>[Enter]
Example RX OK[Enter]
Parameter <Mac Address> R120=FFFFFFFFFFFFFFFF (Default)
Point to Point : 00124B00219ED80D
“Mac Address”
Remark Point to Point communication (1:1)
* Mac Address can be checked by “AT+I or AT+V”
Ex) Master Mac Address : 00124B00219EE627
AT+R120=00124B00219ED81B “Master setting value”
Slaver Mac Address : 00124B00219ED81B
AT+R120=00124B00219EE627 “Slave setting value”
Table 14. AT+R120 description
3.3.5 AT+R130
Function RF hopping mode setting
Example TX AT+R130=<FHSS Mode>[Enter]
RX OK[Enter]
Parameter <FHSS Mode>
0 : Disable
1 : Enable (Default)
Remark
Table 15. AT+R130 description
3.3.6 AT+R140
Function Serial communication path setting
Example
TX AT+R140=<Serial Direction>[Enter]
RX OK[Enter]
Parameter
<Serial
Direction>
0 : UART (JST 6Pin Connector) (Default)
1 : USB (Micro 5Pin)
Remark
AT+R140=0 “UART Communication (JST 6Pin Connector)”
AT+R140=1 “USB Communication (Micro 5Pin)”
Table 16. AT+R140 description