User's Manual
WaveIP
Ltd.
WipAir 6000/3000 Installation Guide
Page
16
of 32
2
2
.
.
3
3
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
O
O
v
v
e
e
r
r
v
v
i
i
e
e
w
w
This section provides installation information for WipAir 6000/3000 system.
Note
:
Outdoor units and antennas should be installed ONLY by experienced
installation professionals who are familiar with local building and safety
codes and, wherever applicable, are licensed by the appropriate government
regulatory authorities. Failure to do so may void the product warranty and
may expose the end user or the service provider to legal and financial
liabilities. WaveIP and its resellers or distributors of this equipment are not
liable for injury, damage or violation of regulations associated with the
installation of outdoor units or antennas.
Typical installation scheme:
WipAir - Outdoor Unit
with integrated Antenna
Outdoor to
Indoor CAT5
Indoor Outlet
User computer
Indoor CAT5
Power
Supply
100-240V
AC
Figure
2-2: WipAir 6000/3000 - General Installation Scheme
Installation process summary:
1) Select the appropriate location for the Outdoor unit and the indoor PoE Outlet.
2) Mount the Outdoor unit. If you are using detached antenna mount the antenna
and connect it to the Outdoor unit.
3) Connect a ground cable between the Outdoor unit and an appropriate
grounding point.
4) Connect the Outdoor-to-Indoor shielded CAT5 cable to the Outdoor unit and
route it to the location selected for the PoE Outlet. Assemble the enclosed
connector on the cable.
5) Mount the Indoor Outlet.
6) Connect the Outdoor-to-Indoor cable to the PoE Outlet ‘OUTDOOR’ port. (This
port supplies 48 VDC in addition to the Ethernet data).