User's Manual
Table Of Contents
WaveIP Ltd. GigAccess™ OFDM 700 RSU
Pa
g
e 7 of 10
• Obtain a clear line of site to the AU as much as possible - avoid any
physical obstacles, which may block the signal.
2
2
.
.
2
2
.
.
3
3
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
The installation process should follow the following steps:
1) Connect the CAT5 Ethernet cable from the RSU data port to your PC NIC. Note
that your RSU consists two Ethernet ports, so you can connect your PC to
either of them, or to connect two PCs; each PC to different Ethernet connector.
2) Connect the power supply to the AC wall socket and to the RSU DC power
port.
WARNING! Use only with the supplied Power Supply adapter
3) Align the RSU until you get the maximum receive signal from your service
provider. Best received indication when maximum “Received Power Indication
LEDs” are light. Check both vertical and horizontal polarization and select the
polarization that gives you the best receiving power. The RSU antenna
polarization must be the same as in the AU antenna. In most applications, the
preferred orientation is vertical polarization. (Above ground propagation of the
signal is better when it is polarized vertically).
4) The RSU will automatically acquire the radio channel of the AU.
• Verify that the Air link led flashes (green led on the Ethernet connector),
which indicated reception from the AU.
• Verify that the Ethernet link led light (yellow led on the Ethernet connector)
when the PC is connected. This led will flash in case of Ethernet data
transaction between the RSU and the PC.
Now you are ready to surf into the Internet.
WARNING! Do not put any obstacle in front antenna. A minimum separation distance
of 20 cm must be maintained between the device in operation and all persons.