GigAccessTM 900 and 900A SelfSelf-Install RSU User Guide
November 2003 Rev. A Table of Contents 1. INTRODUCTION ........................................................................................................... 4 1.1. GENERAL ............................................................................................................................ 4 TM 1.2. GIGACCESS 900 SYSTEM OVERVIEW ................................................................................ 4 2. PACKING LIST ....................................................................
November 2003 Rev. A 1. Introduction 1.1. General Congratulations on your purchase of the WaveIP GigAccess™ 900 self-install Business/Residential Subscriber Unit (RSU). This document describes how to install and use your subscriber unit to obtain wireless high-speed Internet access. You can connect your RSU both to a computer and to a local area network (LAN) through the integrated two ports. 1.2.
November 2003 Rev. A 2. Packing List When you first open the package, verify that the unit is complete and consists: • RSU • Power Supply • Quick Start Guide RSU Part number: RSU-09D-065D-FU. Figure 2-1 illustrates the RSU package contents.
November 2003 Rev. A 3. Installation Process 3.1. General The RSU is a self-installed, plug and play unit, which requires minimum operation from the user. A description of the RSU is given in the figure below. 1. Polarization Indication 2. Air link led (Green) 3. ETH link led (Yellow) 4. Received Signal Indicator Lights 5. ETH Connector 6. Power led 7.
November 2003 Rev. A 3.2. Before You Start 1) Make sure your computer is equipped with an Ethernet Network Interface (NIC) 2) Make sure your computer is set up to automatically obtain an IP address (See 0). 3) Select the appropriate location for the RSU: • Make sure you are operating the RSU in a room near an outside window. • Locate the RSU in such a way that the antenna side will be directed towards your service provider (AU direction).
November 2003 Rev. A AU Direction RSU Power Supply 100-240V AC Ethernet Data Cable CAT5 Figure 3-2: GigAccess™ RSU - Installation Scheme 3.4. Radio Channel Selection The radio channel is defined at the AU side. The RSU is pre-configured to scan all channels. Therefore it will acquire the AU channel automatically. 3.5. User PC Setup Configure the PC NIC to obtain an IP address from DHCP server. For this configuration follow the following steps: • Press right click on the Network Neighborhood Icon.
November 2003 Rev. A 3.7. FCC Information Notice: This device has been tested and found to comply with Radio Frequency Exposure Limits. A minimum separation distance of 30 cm must be maintained between the device in operation and all persons. This device complies with Part 15 of the FCC Rules.
November 2003 Rev. A 4. GigAccessTM 900 RSU Technical Specifications Operating Frequency 902 – 928MHz ISM band Number of Channels 7 (912 – 918) in step of 1MHz in GA_900_RSU 15 (907 – 923) in step of 1MHz in GA_900A_RSU Access technology TDMA (Time division multiple access) Duplexing schemes TDD (Time division duplex) RF Waveform Direct Sequence Spread spectrum (DSSS) Modulation DQPSK, 16CCK , 256 CCK Raw Data Rates 11 Mbps and 5.5 Mbps in GA_900_RSU 1 5.
