User's Manual

February 2003
Rev. A
Page 47 of 47
10.6.3. PLD Window
The PLD Window provides the ability to burn a new firmware to one of the banks (Admin user
only). The new software should not be burned to the actual boot Bank. The actual boot bank is
displayed in the Boot Window. An alert message box is displayed if trying to burn the new
software to the actual boot bank. When submitting the burn operation, log prints are printed to the
log window and log file. When the burn is done the units resets and it is required to reconnect to it
and check that the software was burned (View the Software Window). Finally the boot bank
should be changed in the Boot Window.
Figure 10-8: PLD Window in Unit Manager Tool
10.6.4. PHY Window
The PHY Window provides the ability to burn a new firmware to one of the banks (Admin user
only). The new software should not be burned to the actual boot Bank. The actual boot bank is
displayed in the Boot Window. An alert message box is displayed if trying to burn the new
software to the actual boot bank. When submitting the burn operation, log prints are printed to the
log window and log file. When the burn is done the units resets and it is required to reconnect to it
and check that the software was burned (View the Software Window). Finally the boot bank
should be changed in the Boot Window.
Figure 10-9: PHY Window in Unit Manager Tool