User's Manual

February 2003
Rev. A
Page 44 of 47
10.4.1. Advanced Window
The Advanced Window provides the ability to change more detailed parameters of the unit.
Figure 10-4: Advanced Window in Unit Manager Tool
The Advanced window contains the following fields:
Ø Admin Login Password – the Administrator password that should be entered when trying to
login as an Admin user (Admin user only).
Ø User Login Password – the User password that should be entered when trying to login as
a User user.
Ø Antenna Gain – select the antenna used (Admin user only).
Ø TX Power – Select the output power at the antenna connector (Admin user only).
Changes of the TX Power must be done by an Expert Technician only. This TX Power
value must be set according to the type of the antenna used in order to insure that the
power at the output of the antenna stands in the selected regulation restrictions.
Ø Detached Antenna Select – this field is used to select Internal or Detached antenna
(Admin user only). For now, when the flag is set so the Internal antenna is selected.
The default for this flag is to use internal antenna. Detached antenna should be selected
only when the unit has and detached antenna connector.
Ø Ethernet Switch Port 1 Configuration – set the speed and duplex of port 1. Available values
are: 10M Full Duplex, 100M Full Duplex and Auto-Negotiation.
Ø Ethernet Switch Port 2 Configuration – set the speed and duplex of port 2. Available values
are: 10M Full Duplex, 100M Full Duplex and Auto-Negotiation.
Ø Ethernet Switch Priority – set the priority between the two Ethernet ports. Available values
are: Disabled, Port 1 High Priority and Port 2 High Priority.
Ø Enable Ethernet Switch Security – when this flag is set, traffic between Port 1 to Port 2 is
blocked (VLAN).
Ø Regulation – select the appropriate regulation: FCC or ETSI. (Admin user only).