User's Manual
December 2003
Rev. A
Page 7 of 9
3.6. Safety
1. Do not immerse the equipment in any type of liquid.
2. Only operate the BSU/RSU with the supplied Power Supply! Any other type of input power source
may cause damage and voids the warranty.
3. Do not place the equipment on an unstable surface.
4. Do not disassemble the equipment. Removing covers voids the warranty.
5. Do not expose the equipment to extreme hot or cold temperatures.
3.7. FCC Information
Notice: This device has been tested and found to comply with Radio Frequency Exposure Limits. A
minimum separation distance of 20 cm (8 inches) must be maintained between the device in operation and
all persons.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
FCC Notice, USA
This equipment has been tested and found to comply with the limits for Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient the relocate-receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device must accept any interference received including interference that may cause undesired
operation. Any unauthorized modification or changes to this device without the express approval of WaveIP
may void the user’s authority to operate this device. Furthermore, this device intended to be used only when
installed in accordance with the instructions outlined in this manual. Failure to comply with these instructions
may also void the user’s authority to operate this device and/or the manufacturer’s warranty