User`s guide

Making A PLL Analysis Measurement
Setup Directions
• Open the Advanced PLL tool.
• Connect the signal to a measurement channel (see below). Set the measurement channel in
GigaView by going to the Acquire Option menu and choosing Channel.
• Confirm that a valid signal exists at the measurement channel by using Pulsefind
.
• Set the Rec Length (µs) and the Meas Incr (Periods). All other parameters are left as default.
• Begin acquisition by pressing Single/Stop button on the front panel
.
When acquisition is complete, the Single/Stop button will cease to illuminate.
Section 4 - GigaView © WAVECREST Corporation 2005
82