User`s guide

Making an Oscilloscope Measurement
Setup Directions
This tool requires a signal connected to any available measurement channel. A trigger signal can be
connected to any available channel, or the measurement can be triggered from the measurement channel.
• Verify the proper input signal levels.
• Connect the source to any IN channel.
• Connect a trigger to any IN channel, add the channel and change the trigger/arm channel (see
instructions below). Or, you may select to trigger off of the signal on the measurement channel.
• Press Pulsefind
on the Tool Bar.
• Press Single Acquire
on the Tool Bar.
Use trigger on any input.
Connect to IN of any channel.
Device
Under
Test
Select measurement channel in dialog box.
Select arm channel in Trigger dialog box.
© WAVECREST Corporation 2005 Section 4 - GigaView
43