User`s guide

Connecting and Installing a Printer

If you have a serial printer, you will need a 9-pin to 25-pin serial printer cable.

 Attach the 9-pin small “D” connector to the printer output connector labeled COM2

(RS232) on the back panel of the SIA-3000. Tighten the thumbscrews.

If you have a parallel printer, you will need a parallel printer cable.

 Attach the 25-pin “D” connector to the parallel port.

Once the appropriate printer cable has been attached and the SIA-3000 has been turned on,

 Select Tool/Print Setup/Add Printer from the Menu Bar.

Locate the target printer, whether hooked up locally to the SIA-3000 or over a network, through

the dialog boxes that appear following the Add Printer selection. Make sure the printer driver is

available on a floppy disk or at a network location accessible by you if it is not included on the

SIA-3000 printer list.

Additional printers can be added, removed or configured through the Tool/Print Setup selection by

following the dialog boxes and screen prompts.

WAVECREST Corporation 2005