User`s guide

Window Maximum - Enter maximum filtering time in seconds. See also Filters.
Window Minimum - Enter minimum filtering time in seconds. See also Filters.
Window Width - Enter filter range (0 to ±2.49 seconds) of Window Filter. See also Filters.
Wizard
To use the Wizard:
1) Press the button for the type of measurement you
would like to make.
2) Follow Setup Directions.
3) Choose parameter to be measured. The SIA-3000
will make that measurement. Some measurements
may take a while to complete. Wait for the
"Single/Stop" button to turn off. The measurement
is now complete.
4) Press "Close Wizard" to return to GigiView.
Wordpad - Clicking on this button launches Wordpad.
Work Area - Where active and/or open tools are displayed.
X-axis - Select the horizontal plot axis unit of measure.
Event - Take a measurement for each event from START event to STOP event and plot these values versus the count.
Time - Take a measurement and plot the value versus time.
UI Spans - Shows number of UI spans measured.
Delay Time - Shows time from Arm.
Delay Periods - Shows number of periods from Arm.
Span Periods - Shows number of periods measured.
Span Time - Shows units of time measured.
Measurement - Shows number of total measurements.
Elapsed Time - Shows elapsed acquisition time.
Hit Number - Low Frequency Modulation: Hit number is integer value assigned to each measurement as it is made.
X-Axis (Bathtub) - Select the horizontal plot axis unit of measure.
Y-Axis (Bathtub) - Select the vertical plot axis unit of measure.
Zoom command (Display Menu) - Allows the option of zooming only the x-axis, y-axis or both the x- and y-axes when
utilizing the Zoom In/Out feature.
Zoom Both command (Display menu) - Zooms both the x and y axes when using the Zoom In/Out feature.
Zoom In/Out - The Zoom In/Zoom Out feature is activated using the left button of a pointing device (mouse). To
Zoom In, click and drag using the left mouse button until the area to be enlarged is highlighted. This can be done
repeatedly until the desired magnification is achieved. To Zoom Out, double click the left mouse button.
Zoom Reference - Left will zoom holding the left position. Center will zoom holding the center position. This setting
will affect how the Horizontal Scale knobs zoom on the waveform.
Zoom to Eye - Automatically positions Eye on the display.
337
© WAVECREST Corporation 2005 Glossary