User`s guide

SECTION 3 – Complete Setup of the SIA-3000
This section shows you how to inspect and fully set up the SIA-3000 including the attachment
of accessories and peripheral devices. The following areas are covered in this section:
• Inspection
• Connecting power
• Connecting included accessories
• Connecting peripheral devices
• Verify instrument is taking measurements
Inspection
 Inspect the shipping box for damage.
If the box is damaged, retain it until the contents and instrument have been checked for
damage and proper operation.
 Check for accessories.
 Keyboard
 Pointing device (mouse)
 Power cord
 Two (2) matched 50Ω coaxial cables with SMA connectors
 Two (2) SMA Quick Connect calibration adapters (Minimum 500 uses)
 SIA-3000 User’s Guide and Reference Manual and 3-ring binder
 SIA-3000 GPIB Programming Guide and 3-ring binder
 SIA-3000 LabVIEW Programming Guide and software drivers CDROM
 GigaView Quick Reference Guides and 3-ring binder
If the contents are incomplete or damaged, contact WAVECREST Corporation Customer
Service: 1-800-733-7128
 Inspect the instrument.
If there is mechanical/physical damage, or if the instrument does not power up or boot up
properly, notify WAVECREST Corporation .
If the shipping box is damaged, or the cushioning materials show signs of stress, notify
the shipping carrier as well as the WAVECREST Corporation office. Keep the shipping
materials for the carrier’s inspection. WAVECREST Corporation will arrange for repair
or replacement at their option.
© WAVECREST Corporation 2005 Section 3 - Complete Setup of the SIA-3000
13