User`s guide

Taking a Measurement

 Click the button (Single/Stop) on the tool bar to view a histogram of the 10MHz square wave.

Note: When a tool is first opened, a pulsefind is automatically performed when a measurement is

taken. Should any parameter setting or input signal changes occur, a pulsefind should be

performed prior to taking another measurement.

If an error is received, ensure all connectors are tight and re-activate the 10MHz calibration signal as

described in the previous instructions.

Redo a

Pulsefind ( ) and then take another Single measurement ( ).

WAVECREST Corporation 2005

Section 1 - Quick Setup