User`s guide

Bathtub View
This plot is derived from the TailFit. Using RJ and DJ information it shows a TJ value at a specified Bit
Error Rate (BER default is 1*10
-12
). The thick part of the line indicates measured values; the thin part
indicates calculated values. The color stops at the BER where TJ is determined.
The plot gives the user information about failure (when the lines cross) and margin, if the part fails below
the specified BER.
Horizontal x-axis shows Time (of one unit interval) or Unit Interval.
Vertical y-axis shows the BER.
Cursor coordinates are displayed on the bottom status line.
© WAVECREST Corporation 2005 Section 4 - GigaView
149