User`s guide

 Attach coax cable to the (Channel 1) IN 1 connector. Ensure there is a tight connection.
 Attach other end of coax cable to the Calibration OUT connector. Ensure there is a tight
Connection (~7-9 in/lbs).
 Plug female end of power cord into power cord connection on back of unit.
 Plug male end of power cord into an appropriately grounded 115 VAC source.
 Turn on power by pushing the power button at the bottom right-hand corner of the front panel.
After a few minutes, the opening view of GigaView’s work area will be displayed.
Section 1 - Quick Setup © WAVECREST Corporation 2005
2