User`s guide

SECTION 1– SIA-3000™ Quick Setup and Measure
This section helps the user to quickly set up the WAVECREST Signal Integrity Analyzer 3000 (SIA-
3000) and take a simple measurement using the 10MHz
Calibration OUT signal. In addition, this section
will assist the user in calibrating the SIA-3000. The accessories included with the unit are listed below.
Accessories
 Keyboard
 Pointing device (mouse)
 Power cord
 Two (2) 50Ω coaxial cables with SMA connectors
 SIA3000 User’s Guide and Reference Manual
 SIA3000 GPIB Programming Guide
 Two (2) SMA Quick Connect adapters for calibration (minimum 500 uses)
Quick Setup and Simple Measurement of 10 MHZ Calibration Signal
This section will show the user how to:
• Attach the included keyboard, mouse and power cord to the SIA-3000
• Attach a coax cable to an input channel and the Calibration OUT signal
• Open a GigaView measurement tool
The following steps will show the user how to attach the keyboard, mouse, coax cable and power cord.
 Plug keyboard USB cable connector into one of the two USB ports on the front of the SIA-3000.
 Plug mouse USB cable connector into remaining USB port on the front of the SIA-3000.
© WAVECREST Corporation 2005 Section 1 - Quick Setup
1