User`s guide

Making A DRCG Measurement
Setup Directions
Connect the clock source to be analyzed to a measurement channel. From the front panel, verify under
'Acquire Options' that the correct measurement channel is set. Press pulsefind and single acquire.
• Verify that a signal is connected to an input channel and that the proper channel is chosen in the menu.
• On the top toolbar press Pulse Find . Verify the voltage levels and close out the pulse find box.
• Press the Single Acquire button or press the Run/Cycle button allowing the instrument to
accumulate a continuous series of measurements.
• Press the Single Acquire button or the Stop button to stop the cycling process.
Section 4 - GigaView © WAVECREST Corporation 2005
120