User`s guide

Making a Measurement
Setup Directions
This tool requires an Arming signal. With Locktime, the user is able to make synchronous, single channel
measurements.
• Verify the proper input signal levels.
• Connect the source to any channel
• Connect an arm signal to any open channel
Device
Under
Test
PLL Outpu
t
Si
g
nal Generator
Frequency Lock Si
g
nal
The arm signal provides a point of reference for the measurements to be made. For measuring PLL
locktime, period or frequencies are measured. These measurements are made by automatically
incrementing the Delay until the Span value is reached.
Section 4 - GigaView © WAVECREST Corporation 2005
102