User`s guide

ManualsBrandsWavecrest ManualsTV Converter BoxOE-2

Table Of Contents

copyrt_2002e.pdf
- Eden Prairie, Minnesota 55344
PrefaceF.pdf
- PREFACE
Sect_1f.pdf
- SECTION 1– Introduction
  - - - Features
      - GPIB Interface - The OE-2 can be run remotely via the GPIB or locally via the front panel.
        Figure 1 – Dual-Channel OE-2 shown with WAVECREST
        How the OE-2 Works
        Laser Safety
Sect_2h.pdf
- SECTION 2 – Front and Back Panel Descriptions
Sect_3k.pdf
- SECTION 3 – Setup and Measurement
APPENDAj.pdf
- APPENDIX A – Specifications and Requirements
  - - - Functional Specifications—Electrical and System
        Power Requirements
        Communications Requirements
        Environmental Requirements
        Fuse Replacement
        Cleaning Instructions
    - Intended Use Of Equipment
APPENDBd.pdf
- APPENDIX B - GPIB Commands
  - - - OE-2 Specific Commands Description
        INStalled: Channel subcommand that provides a query response only. When queried the command returns a comma delimited field with information pertaining to the specified channel. The fields returned are channel type (or option), current filter setting
APPENDC4.pdf
- APPENDIX C – Preprogrammed Measurement Limits
  - - - Filter
        Wavelength
        Filter
        Wavelength
        Filter
        Wavelength
        Filter
        Wavelength
copyrt_2002f.pdf
- Eden Prairie, Minnesota 55344
Sect_3k.pdf
- SECTION 3 – Setup and Measurement
APPENDAk.pdf
- APPENDIX A – Specifications and Requirements
  - - - Functional Specifications—Electrical and System
        Power Requirements
        Communications Requirements
        Environmental Requirements
        Fuse Replacement
        Cleaning Instructions
    - Intended Use Of Equipment

VISI SOFTWARE SETUP

Controller Mode

Edit | Configuration Menu

In order for the OE-2 to communicate with the SIA-3000™ using the GPIB bus, the SIA-

3000

must be in the “Controller” mode. To select Controller mode:

 Select Edit | Configuration on the

(pull-down) Menu Bar

 Select OE-2 in the Target

Device pull-down Menu

 Select Controller in the GPIB

Board Mode pull-down menu.

 Click “Apply”

 Click “Close”

Optical Configuration

The Optical Configuration menu enables the user to:

• Set up the IEEE-488 (GPIB) addresses for one or more OE-2’s (up to five OE-2’s can

be addressed in a single VISI-based system).

• Assign each OE-2 channel to a

WAVECREST

SIA or DTS instrument channel.

• Set preliminary optical measurement parameters.

To access the

Optical Configuration menu in VISI, select Edit|Optical Configuration on the (pull-

down) Menu Bar (see figure below).

| Section 3 | Setup Measurement