User`s guide

Laser Safety
Although the
OE-2 optical to electrical converter does not emit laser energy, it does process
optical signals from laser devices. Therefore, laser signals will be present at the OE-2 inputs.
These signals present retinal and/or personal hazards because they are invisible and might not be
detected until injury to the eye or skin has occurred. To prevent injuries, basic precautions
should be followed.
• NEVER look directly into an optical signal connector. Always assume a laser beam is present.
• NEVER direct an optical output signal connector in a direction that could cause harm to
personnel nearby.
• Always turn optical output signal devices OFF when not in use.
• Where practical, protective eyewear that is designed for the signal wavelengths used should
be worn.
Section 1 | Introduction |
3