Technical data

WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC Friday 21 May 1999
WAVECOM confidential © 74
4.10.2 Automatic RxLev indication +CCED
The CCED command has been extended to indicate the the received signal
strength indication (rssi) of the main cell. The principle of the command is
not changed:
Command Syntax: AT+CCED=<mode>[, <requested dump>]
* <mode>:
0 One shot requested
1 Automatic shots requested
2 Stop automatic shots
* <requested dump>:
8 Main cell RSSI indications (RxLev) from 0 to 31
The response will be a +CSQ answer and not a +CCED answer. The 07.07
format for the +CSQ is respected. The <ber> is not evaluated by this
command, so the <ber> value will always be 99.
+CSQ:<rssi>, 99
OK
This +CSQ answer, when automatic shots are selected, is sent every time
the <rssi> measured by the module changes. This automatic shots are
supported in idle mode and during communication.
Combination (addition of the values) of the requested dumped (1,2,4,8) are
supported. Both answer +CCED and +CSQ may be then generated.