Technical data

WMO2 G900 / G1800 / G1900

WCOM/GSM/WMO2/WMO2ATDOC Friday 21 May 1999

WAVECOM confidential © 72

4.9.6 Set DSR signal &S

This commands controls the Data Set Ready (DSR) signal.

Application to GSM AT&S0 DSR always on

GSM to application OK command valid

Application to GSM AT&S1 DSR off in command mode, DSR on in data mode

GSM to application OK command valid

4.9.7 Back to online mode O

If you have established a connection and the mobile is in online command

mode, this command allows to return to online data mode.

Application to GSM ATO

GSM to application OK Command valid

4.9.8 Result code suppression Q

Determines whether the mobile sends result codes or not

Application to GSM ATQ0 DCE transmits result codes

GSM to application OK Command valid

Application to GSM ATQ1 Result codes are suppressed and not transmitted

GSM to application (none) no response

4.9.9 DCE response format V

Determines the DCE response format, with or without header characters

<CR><LF>, and with the use of numeric result codes.

V0 V1

Information responses <text><CR><LF> <CR><LF>

Result codes <numeric code><CR> <CR><LF>

Application to GSM ATV0 DCE transmits limited headers and trailers and numeric result codes

GSM to application 0 command is valid (0 means OK)

Application to GSM ATV1 DCE transmits full headers and trailers and verbose response text

GSM to application OK command is valid

4.9.10 Default configuration Z

Restores the configuration profile.

Application to GSM ATZ

GSM to application OK Command valid

4.9.11 Save configuration &W

This commands writes the active configuration to a non-volatile memory

(EEPROM). Description of the stored parameters is in Erreur! Source duErreur! Source du

renvoi introuvable.renvoi introuvable.

Application to GSM AT&W Writes current configuration to E2prom

GSM to application OK command valid