Technical data

WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC Friday 21 May 1999
WAVECOM confidential © 64
4.7.7 Connected line identification presentation +COLP
This command allows control of the connected line identification
presentation supplementary service, useful in case of call forwarding of the
connected line.
Command syntax: AT+COLP=<n>
Response syntax: +COLP: <n>,<m> (for AT+COLP?)
Intermediate message: +COLP: <number>,<type> (after ATD)
<n>: parameter sets/shows the result code presentation status in the TA
0 Disable
1 Enable
<m>: parameter shows the subscriber COLP service status in the network
0 COLP not provisioned
1 COLP provisioned
2 Unknown (no network...)
Application to GSM AT+COLP=1 Activate COLP
GSM to application OK Command valid
Application to GSM AT+COLP? Ask for current functionality
GSM to application +COLP: 1,1
OK
COLP is enabled and provisioned
Application to GSM ATD146290800; Outgoing call
GSM to application +COLP: "0146290928",129
OK
Connected outgoing line presentation
Application to GSM AT+COLP=0 desactivate COLP
GSM to application OK command valid