Technical data

WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC Friday 21 May 1999
WAVECOM confidential © 63
4.7.5 Calling line identification restriction +CLIR
This command allows control of the calling line identification restriction
supplementary service.
Command syntax: AT+CLIR=<n>
Response syntax: +CLIR:<n>,<m> (for AT+CLIR?)
* <n>: parameter sets the adjustment for outgoing calls
0 Presentation indicator is used according to the subscription of the CLIR service
1 CLIR invocation
2 CLIR suppression
* <m>: parameter shows the subscriber CLIR status in the network
0 CLIR not provisioned
1 CLIR provisioned in permanent mode
2 Unknown (no network...)
3 CLIR temporary mode presentation restricted
4 CLIR temporary mode presentation allowed
Application to GSM AT+CLIR=2
GSM to application OK command valid
Application to GSM AT+CLIR? Ask for current functionality
GSM to application +CLIR: <n>,<y>
OK
<n> and <m> defined as above
4.7.6 Calling line identification presentation+CLIP
This command allows control of the calling line identification presentation
supplementary service:
Command syntax: AT+CLIP=<n>
Response syntax: +CLIP: <n>,<m> (for AT+CLIP?)
Unsolicited message: +CLIP: <number>, <type> (for incoming call)
* <n>: parameter sets/shows the result code presentation in the TA
0 disable
1 enable
• <m>: parameter shows the subscriber CLIP service status in the network
0 CLIP not provisioned
1 CLIP provisioned
2 Unknown (no network...)
Application to GSM AT+CLIP=1 Enable CLIP
GSM to application OK CLIP is enabled
Application to GSM AT+CLIP? Ask for current functionality
GSM to application +CLIP: <n>,<m>
OK
<n> and <m> defined as above
GSM to application RING
+CLIP: "0146290800",129
Incoming call
Incoming call number presentation
Application to GSM AT+CLIP=0 Disable CLIP presentation
GSM to application OK Command valid