Technical data

WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC Friday 21 May 1999
WAVECOM confidential © 31
4.2.7 Automatic answer ATS0
This S-parameter controls the automatic answering feature of the mobile.
Application to GSM ATS0=2 Automatic answer after 2 rings
GSM to application OK
Application to GSM ATS0? Current value
GSM to application 002
OK
always 3 characters with leading zeros
Application to GSM ATS0=0 no automatic answer
GSM to application OK command valid
All others S-parameters (S6,S7,S8 ...) are not implemented.
4.2.8 Incoming Call Bearer +CICB
Command syntax: AT+CICB= <mode>
This specific command is used for incoming call type when no incoming
bearer is given (single numbering scheme).
<mode> values:
0: Data
1: Fax
2: Speech
Application to GSM AT+CICB=1 If no incoming bearer, force a fax call
GSM to Application OK Command accepted
Application to GSM AT+CICB=2 If no incoming bearer, force a speech call
GSM to Application OK Command accepted
Application to GSM AT+CICB? Interrogate value
GSM to Application +CICB: 2 Default incoming bearer: speech call
Application to GSM AT+CICB=? Test command
GSM to Application +CICB: (0-2) Speech, data or fax default incoming
bearer