Technical data

WMO2 G900 / G1800 / G1900
WCOM/GSM/WMO2/WMO2ATDOC Friday 21 May 1999
WAVECOM confidential © 20
3.2 Default settings
The following table shows the different storable parameters, the
command to store them and there default value.
CommandCommand AT&WAT&W (E2P) (E2P) AT+CSASAT+CSAS
(SIM, E2P)(SIM, E2P)
Default valueDefault value
+CMEE X 0
+CSCS <char. set> "PCCP437"
ATS0 <# of Ring> 0 (no auto-answer)
+CICB X 2 (speech)
+VGR <n> 2 (all speakers)
+VGT <n> 2 (all microphones)
+SPEAKER X 0 (Speaker 0 & Micro 0)
+ECHO All 160, 12, 5, 512, 10
+SIDET X 1,1
+CREG <mode>,<form> 0
+CLCK X No SIM or Network lock
+CPWD <pwd> 00000000 (SIM & Net lock)
+WAIP <mode> 0
+CMGF <mode> 1 (text)
+CSDH X 0
+CNMI All 0, 0, 0
+CSMP All 1, 67, 0, 0
+CSCA <sca> SIM dependant (phase 2)
+CCWA <n> 0
+CLIR <n> 0
+CLIP <n> 0
+COLP <n> 0
+CBST All 0, 0, 1
+CRLP All 61, 61, 48, 6
+CR <mode> 0
+CRC <mode> 0
+IPR X 0 (autobaud)
+IFC X 2,2
+ICF X 3,4
E X 0
&C X 1
&D X 1
Q X 0
V X 1
&S X 1
The default setting of the RS232 serial link handler shown above in
the table corresponds to the following setting:
Baud rate : Autobauding (admitting rates from 2400 to
19200 bps)
Data length : 8 bits
Parity : None
Stop bit : 1
Flow control : Hardware (RTS/CTS)
To tune this settings please use the commands +IPR, +IFC and
+ICF.