User manual

Wavecom Instruments Portable Appliance Testers Instruction Manual

Important Information

Accessories Supplied

Portable Appliance Tester Instruction Manual

Manufacturer‟s 1

Calibration Certificate – (Valid for 12 months)

IEC test lead (500mm orange/red)

Earth Lead with Alligator Clip (1800mm black)

Soft Carry Case

Locking IEC Power Cable (1800mm Blue)

Precautions

Manufacturer Recommendations

Calibration:

The manufacturer recommends a routine calibration / verification of this unit to ensure the

accuracy of readings on a 12 monthly basis, or as prescribed under any additional local Regulatory

requirements.

Note: Only Wavecom Instruments or its Authorised Service Agents are permitted to repair and Calibrate this

Instrument. Failure to perform unauthorised service or repair may void all warranties and Calibration Status.

Safety Warning

This 4

Generation TnT series of products have been designed to meet stringent safety requirements,

however no device can completely protect persons from the consequences of incorrect use.

The testing of Electrical appliances requires that extra care and caution is taken at all times to ensure

personal safety.

The Manufacturer also advises that appliance testing should be conducted by a Competent and suitably

trained person, as referred to under the current Standard AS3760:2010, as well as any additional legislation

or rulings in different states.

If in doubt, the manufacturer suggests the user contact their responsible Authority.

For maximum safety, always ensure that the following advice is followed:

The equipment being tested is in good repair.

All user instructions are followed.

Double check power supply connections. (note LED status)

Always use specified fuses and protection devices.

Do not use leads that require repair or are damaged.

If you are unsure, call a licensed Engineer/Electrician. * See P.5 AS/NZ 3760:2010 def.

Unique Locking Power Cable:

Please make sure yellow lever is depressed prior to removal of

the locking power supply cable.

Though the case of the G4 TnT is manufactured from impact

resistant & flame retardant ABS, failure to do so, combined

with excessive force may damage the rear panel.

This revolutionary locking, removable cable is intended to not

dislodge during any portable test procedure.