User manual

Wavecom Instruments Portable Appliance Testers Instruction Manual
24
Edit User X ALP
Entering a user is the same process as entering a site, please refer to the Adding
a Site steps above, Note: The user name will not appear on the initial screen
once selected.
Users 1 - 3
User 1
User 2
User 3
Once a user has been entered, the 'F' buttons are used to select the user. For
example to select user 1, F1 would be pressed.
Auto Generate Barcode Function
If required the auto generate barcode number can be set before testing. The auto generate is always
displayed in the bottom left hand corner of the new barcode screen.
Screen
Instruction
Site x
New Barcode
0000000 5000
The TnT incorporates an auto generate barcode function which allows
barcodes to be generated sequentially after a barcode has been specified, for
example: the specified barcode is 1000 so the next barcode to be generated will
be 1001, 1002, 1003 etc. This can be accessed by holding F3 for 2 seconds on
the Barcode Entry screen.
Barcode Length:
Up 7 Digits
Down
Esc Set
Once the auto generate menu has been accessed, the user can specify how
many digits they want in the barcode. The auto generate function allows a
minimum of 2 and a maximum of 7 digits in the barcode to be generated. To
increase the number of digits in the barcode, press F1. To decrease the number
of digits in the barcode, press F2. To proceed, press enter, or to return to the
Barcode Entry screen, press F3.
Set Barcode:
xxxxxxx
Esc Set
If enter was pressed, the user can now set the barcode that will begin the
sequence. Key in a barcode and press enter to continue, or F3 to return the
Barcode Entry screen.
Use Leading
Zeros
Enable Disable
If enter was pressed, the user can specify whether or not to use leading zeros in
the auto generated barcode. For example: If the user selected 7 digits in the
barcode and entered 1000 as the barcode, the barcode will be 0001000 if leading
zeros are enabled. To enable leading zeros press F3. To disable, press
enter. The current barcode that will be generated is displayed in the bottom left
hand corner of the Barcode Entry screen.
Site x
New Barcode
0001000 5000
The current barcode that will be generated is displayed in the bottom left hand
corner of the Barcode Entry screen.
Entering Items
Screen
Instruction
Site x
New Barcode
0000000 5000
Type in the new barcode or press F3 quickly to choose the auto generate
number. Once a barcode has been specified, items can be entered. If the screen
displays "search barcode" press enter to switch to new barcode. There must be
no numbers entered in to switch between the two modes.
Loc | Desc | Make
A selection of details can be entered for an item. Details include; location,
description, make, model, serial number, asset number, frequency of test and
notes. Each heading relates to an 'F'; e.g. Loc = F1, Desc = F2 and Make =
F3. Only 3 items are displayed at one time. To scroll through the various details,
press enter key. By continually pressing enter you can loop back to the first 3
items. Please make sure location, description are filled out and check to see that
the frequency is correct. Once the details are entered hold the enter key for 2
seconds to move on to the visual check screen.
Location ALP
Entering an items details is the same process as entering sites and users, please
refer to the Adding a Site/User steps above. Ensure that test frequency for the
item is set in accordance with the AS/NZ 3760 Standard