User manual

Wavecom Instruments Portable Appliance Testers Instruction Manual
23
Adding New Equipment
The following must be done before testing:
Create a site or use and existing site.
Create a user name to under the users list.
If auto generate number is used the initial number must be set correctly.
If you are adding equipment to an existing site please make sure that the correct site is displayed. If
the wrong site is displayed the equipment will be assigned to the wrong site.
When the testers memory has been erased it will look like the following screen.
Screen
Instruction
< F1 Select Site
New Barcode
0000000 5000
When the initial screen in memory mode operation is displayed. A site and user
must be entered before testing can be done. When using the TnT for the first
time, < F1 Select Site will be flashing in the top region of the screen.
Adding a Site
Screen
Instruction
New Barcode
0000000 5000
From the initial screen, press F1. Don't hold the F key, this will select a different
function.
Sites 1 - 3
The TnT can hold up to 16 sites. To scroll through the sites, press enter. 3 sites
will be shown on each screen. Each site corresponds to an "F" key, for example
Site 1 = F1. To edit a site, hold the corresponding "F" key for 2 seconds. If the
Site has a * symbol next to the name then the site name cannot be altered. This
site was uploaded from WinPATS and needs to remain the same.
Edit Site X ALP
Using the keypad, enter the name of the site. The Keypad operates in 3 modes-
Alpha, Numeric and Predictive. When an editable screen is entered, there will
be an ALP, NUM or PRE in the top right hand corner of the screen. If you are
using a full size half size keyboard then the 3 modes don't apply. Leave the text
on ALP mode. Once the details have been typed in press enter to return.
Note: Predictive mode will only work if a dictionary has been uploaded from
WinPATS MX. Once a site has been entered, press enter.
Sites 1 - 3
Site 1
Site 2
Site 3
Once a site has been entered, the 'F' buttons are used to select the site. For
example to select site 1, F1 would be pressed.
Site 1
New Barcode
0000000 5000
Once a site has been selected, the TnT will return to the initial screen and the
site that was selected will be shown in the top left hand corner of the screen.
Adding a User
Screen
Instruction
New Barcode
0000000 5000
From the initial screen, press F2. Don't hold the F key, this will select a different
function.
Users 1 - 3
The TnT can hold up to 6 users. To scroll through the users, press enter. 3 sites
will be shown on each screen. Each site corresponds to an "F" key, for example
User 1 = F1. To edit a user, hold the corresponding "F" key for 2 seconds.