Instruction manual

26
Adding New Equipment
The following must be done before testing:
 Create a site or use and existing site.
 Create a user name to under the users list.
 If auto generate number are used the initial number must be set correctly.
 If you are adding equipment to an existing site please make sure that the correct site is displayed. If the wrong site is displayed the
equipment will be assigned to the wrong site.
When the testers memory has been erased it will look like the following screen.
Screen
Instruction
< F1 Select Site
New Barcode
0000000 5000
The initial screen in memory mode operation. A site and user must be entered before testing
can be done. When using the TnT for the first time, < F1 Select Site will be flashing in the top
region of the screen.
Adding a Site
Screen
Instruction
New Barcode
0000000 5000
From the initial screen, press F1. Don't hold the F key, this will select a different function.
Sites 1 - 3
The TnT can hold up to 16 sites. To scroll through the sites, press enter. 3 sites will be
shown on each screen. Each site corresponds to an "F" key, for example Site 1 = F1. To edit
a site, hold the corresponding "F" key for 2 seconds. If the Site has a * symbol next to the
name then the site name cannot be altered. This site was uploaded from WinPATS and needs
to remain the same.
Edit Site X ALP
Using the keypad, enter the name of the site. The Keypad operates in 3 modes, Alpha,
Numeric and Predictive. When an editable screen is entered, there will be an ALP, NUM or
PRE in the top right hand corner of the screen. If you are using a full size half size keyboard
then the 3 modes don't apply. Leave the text on ALP mode. Once the details have been typed
in press enter to return.
Note: Predictive mode will only work if a dictionary has been uploaded from WinPATS MX.
Once a site has been entered, press enter.
Sites 1 - 3
Site 1
Site 2
Site 3
Once a site has been entered, the 'F' buttons are used to select the site; for example to select
site 1, F1 would be pressed.
Site 1
New Barcode
0000000 5000
Once a site has been selected, the TnT will return to the initial screen and the site that was
selected will be shown in the top left hand corner of the screen.
Adding a User
Screen
Instruction
New Barcode
0000000 5000
From the initial screen, press F2. Don't hold the F key, this will select a different function.
Users 1 - 3
The TnT can hold up to 6 users. To scroll through the users, press enter. 3 sites will be
shown on each screen. Each site corresponds to an "F" key, for example User 1 = F1. To
edit a user, hold the corresponding "F" key for 2 seconds.