Instruction manual

14
Caution: This test turns the Device Under Test (DUT) ON. The power / leakage test can handle up to 10 Amp (Resistive) Load
MAX. Exceeding this value will blow the external M205 ceramic fuse. Care should be taken when testing inductive loads (ie AC
motors) with large start up currents. To stop operation press and hold the Return/Enter key at any time. The unit will power
down after 20 seconds as default.
If 10A HBC fuse is blown the appliance will not operate in Power test or Leakage test modes. Replace fuse only with M20 10A
HBC fuses. Any other fuse voids warranty and manufacturers design. Do not open TnT case as there are no serviceable parts
inside.
.
TnT+
Part No: WCM-TNT+
TnT+ Test Function Flow Chart