Instruction manual


 

Page 25
!
Chapter 3 – TnT+ Portable Appliance
Test Instructions
[continued] POWER TEST
Menu 2
More Information re Power Test
This test is Ideal for service agents and electricians. The User can plug in the appliance and turn it
on with real time measurements displayed on the display. This is useful when testing a DUT with
a compliance/name plate on it. The operator can compare the name plate details of operating
voltage, operating current, and power factor etc. should the appliance exceed the said values on
the name plate it could be deemed faulty and require service.
To select the second menu, press and release the RETURN/ENTER Button.
This Menu will display 3 functions:
Power Test
Leakage Test
RCD Test
The Power Test allows the user to turn the appliance on and measure its performance as
a digital wattmeter. Displayed parameters are:
Volts AC
Current
Volt Amps
Power factor
Watts
Before operating, Ensure the equipment firmly secured and is free from any
possibility of causing injury or damage. This function turns the appliance on any,
rotating devices have clearance from body or object. Appliances will jump of
benches if not secured properly.
! CAUTION this test turns on the appliance under test. 10 Amp
(Resistive) Load MAX.
To begin the operation Press and Hold F1 key for 2 seconds to start test.
To Stop operation Press Return /Abort key at any time .
The unit will power down after 20 seconds as default
If 10A HBC fuse is blown appliance will not operate in Power test or Leakage test modes. Replace
fuse only with M20 10A HBC fuses. Any other fuse voids warranty and manufacturers design. Do
not open TnT case as there are no serviceable parts inside.
LEAKAGE
TEST [refer pg 20-21]