Specifications

Product Technical Specification & Customer Design Guidelines
Consumption Measurement Procedure
© Confidential
Page: 97 / 116
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without
prior written agreement.
WA_DEV_Q64_PTS_001-003 January 9, 2009
4.2.2 Equipment Configuration
The communication tester is set according to the Wireless CPU
®
operating mode.
Paging during idle modes, Tx burst power, RF band and GSM/DCS/GPRS may be
selected on the communication tester.
Network analyzer configuration according to operating mode:
Operating mode Communication tester configuration
Alarm Mode N/A
Paging 9 (Rx burst occurrence ~2s)
Fast Idle Mode
Paging 2 (Rx burst occurrence ~0,5s)
Paging 9 (Rx burst occurrence ~2s)
Slow Idle Mode
Paging 2 (Rx burst occurrence ~0,5s)
Fast Standby Mode N/A
Slow Standby Mode N/A
PCL5 (TX power 33dBm)
850/900 MHz
PCL19 (TX power 5dBm)
PCL0 (TX power 30dBm)
Connected Mode
1800/1900 MHz
PCL15 (TX power 0dBm)
Gam.3 (TX power 33dBm)
850/900 MHz
Gam.17 (TX power 5dBm)
Gam.3 (TX power 30dBm)
Transfer Mode class 8
(4Rx/1Tx)
1800/1900 MHz
Gam.18 (TX power 0dBm)
Gam.3 (TX power 33dBm)
850/900 MHz
Gam.17 (TX power 5dBm)
Gam.3 (TX power 30dBm)
1800/1900 MHz
Gam.18 (TX power 0dBm)
Gam.5 (TX power 26dBm)
GPRS
Transfer Mode class 10
(3Rx/2Tx)
1800/1900 MHz
Gam.18 (TX power 0dBm)
The standalone power supply may be set from 3.2V to 4.5V.
The power supply (VCC) used for measurement may be set from 3.2V to 4.8V
according to the Wireless CPU
®
VCC specifications.