Specifications

Product Technical Specification & Customer Design Guidelines
Interfaces
The Q64 UART1 is designed to operate with all serial interface signals. It is
mandatory to use RTS1 and CTS1 for hardware flow control in order to avoid data
corruption during transmission.
Warning: If you want to activate Power down mode (Wavecom 32K mode) in your
Open AT
®
application, you need to connect the DTR1 to a GPIO. Please refer to the
document
[4] AT Command Interface Guide for Open AT® Firmware v6.5 (see the
“Appendixes”) for more information on Wavecom 32K mode activation using the
Open AT
®
Software Suite.
© Confidential
Page: 38 / 116
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without
prior written agreement.
WA_DEV_Q64_PTS_001-003 January 9, 2009