Specifications

Product Technical Specification & Customer Design Guidelines
Interfaces
© Confidential
Page: 23 / 116
This document is the sole and exclusive property of WAVECOM. Not to be distributed or divulged without
prior written agreement.
WA_DEV_Q64_PTS_001-003 January 9, 2009
3.3 Power Consumption
Power consumption depends on the configuration. Therefore, the following
consumption values are given for each mode, RF band and type of software used
(with or without an Open AT
®
application).
Note: The following information is provided assuming a 50
Ω RF output.
The following consumption values were obtained by performing measurements on
Q64 samples at a temperature of 25° C.
Three VCC values are used to measure the consumption, VCC
MIN
(3.2V), VCC
MAX
(4.8V)
and VCC
TYP
(3.6V).
The average current is given for the three VCC values and the peak current given is
the maximum current peak measured with the three VCC voltages.
For more detailed descriptions of the operating modes, (refer to the document
[4] AT
Command Interface Guide for Open AT
®
Firmware v6.5).
For more information about the consumption measurement procedure, refer to
section 4.